Flexit Nordic S3 - Cleaning and Maintenance; Fan Cleaning

10
NORDIC S3
To avoid accidental swapping of the
fans, it is recommended that only
one fan is switched off at a time.
i
To take out the fans:
1. Undo the screws on the electric cover and take
thecovero.
2. Disconnect the electric quick-release contact
by pressing in at the same time as pulling the
contactapart.
3. Remove the plug from the fan compartment cover.
4. Pull the cable bushing on the fan compartment
cover out of the groove so that the cable with quick-
release contact comes too.
5. Remove the cover from the fan compartment.
6. Pull the remainder of the fan cable bushing out of
the grooves so that the cables with quick-release
contacts come too.
7. Remove the fan.
4. Cleaning and maintenance
!
Before opening the door: Switch
off the heat, let the fans continue
for 3minutes to remove hot air,
unplug the unit and wait 2 minutes
before opening the doors.
4.1. CLEANING THE FANS
Cleanthefansatthetimeintervalsspeciedinchap.5.
Maintenance table on page 16. Clean the fan blades
with a grease solvent on a cloth (e.g. methylated spirits)
and compressed air if possible.
NB: Take care that the motor is not exposed to water.
5
1
3
7
2
4
6
x2