Flexit Nordic S3 - Rotor Cleaning; External Unit Cleaning

15
NORDIC S3
4.4. CLEANING THE ROTOR
Ahigh-impermeabilitylterisinstalledintheunit.
Itisnotthereforeusuallynecessarytocleantherotor.
If,foranyreason,itshouldstillbenecessary,dustcan
beremovedwithasoftbrush.
Further cleaning is possible by removing the rotor,
spraying it with a grease solvent and then blowing it
clean from the opposite side. Distance approximately
60mmandmax.pressure8bar.
Ensure that the motor is not exposed to water during
cleaning. Ensure that all seals around the rotor are intact
and tight. Ensure that there is no damage to the rotor
belt, and that the rotor rotates freely.
4.5. EXTERNAL CLEANING
Many kitchen surface cleaners contain chemicals
thatmaydamagetheproduct’splasticcomponents.
Therefore use a soft cloth moistened with warm water
and a neutral detergent to clean the outside of the
product.
Do not use sharp objects, powerful
cleaners or scouring powder, as
such products can damage the
surfaces.
i
Cleaners containing ammonia or
citrus must not be used. Products
that give stainless steel an anti-
fingerprint coating must not be
usedeither.
i
12. Thenscrewthesteelprolebackon.Pressthesealing
striptowardstheshortendofthesteelproletoform
aseal.Theprolealsohasasealingstripalongoneside.
!
It is important to screw the profile
on the right way so that the seal
sits tightly against the partition
inside the unit.
NB:
13. Push the rotor back in.
12
13