Flexitron Webdyn WebdynModbus - Page 25

contact@webdyn.com | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
25
4. FTP server:
To enable the gateway to communicate with a remote FTP server (via Ethernet OR modem), enter the
following information:
• Server: IP Address or symbolic name of the remote FTP server.
• Login: User ID used by the gateway for connection to the remote FTP server.
• Password: Password used by the gateway for connection to the remote FTP server.
• Port: Port number used for communications with the remote FTP server (default: 21).
• Setup: Name of the Conguration directory (default: /CONFIG).
• Denition: Name of the Denition directory (default: /DEF).
• Data: Name of the Data directory (default: /DATA).
• Alarms: Name of the Alarms directory (default: /ALARM).
• Commands: Name of the Commands directory (default: /CMD).
• Log: Name of the Log directory (default: /LOG).
• Firmware: Name of the directory for downloading new rmware (default: /BIN).
• Authorise the overwriting of the distant les: when this option is active, the concentrator can,
further to a local modication, overwrite conguration and denition les available on the FTP
server.
Check that the FTP directories dened actually exist on the FTP server. The gateway does not
create any directories on the server.
For UNIX servers, the names are case sensitive (lower/UPPER case).
5. Web Services:
If the gateway has to use a connection to Web Services, enable this option and ll in the URL of the server.
Otherwise, disable this option.
Once all the parameters have been specied, click on OK.
A message will appear at the top of the page to indicate that the gateway must be restarted to take the
new parameters into account.