Flexitron Webdyn WebdynModbus - Page 34

contact@webdyn.com | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
34
DAQ_
PeriodSec
Collection interval in seconds common
to all data sources (Inverters, TIC, I/O,
Modbus)
Considered only if DAQ_Period is
equal to 0
Possible value
from 0 to 59
seconds
0
If the collection period congured is less than the real data acquisition period, the data will be
timestamped at the acquisition period.
A data acquisition time slot can be dened using the variables listed below, in the le prexID_var.ini.
VARIABLE DEFINITION DEFAULT VALUE
DAQ_
TimeZoneStartHour
Acquisition start hour 0
DAQ_
TimeZoneStartMinute
Acquisition start minute 0
DAQ_
TimeZoneStopHour
Acquisition end hour 0
DAQ_
TimeZoneStopMinute
Acquisition end minute 0