Need help?Do you have a question about the Flexitron Webdyn WebdynModbus and is the answer not in the manual?
General| Manufacturer | Flexitron |
|---|---|
| Category | Control Unit |
| Model | WebdynModbus |
| Protocols | Modbus |
| Communication | RS485 |
Details the validity of the manual for specific hardware and software versions.
Identifies the intended users of the manual.
States the manual's version.
Highlights essential safety recommendations to prevent damage and injury.
Presents a diagram illustrating the gateway's role in a monitoring system.
Lists electrical, GSM/GPRS antenna, memory, dimensions, and environmental specifications.
Details the data sources, communication channels, and remote servers supported.
Describes optional accessories like the DIN Rail Power Supply and GSM/GPRS antennas.
Specifies required FTP server configurations and necessary directories.
Explains the need for NTP server synchronization for correct time settings.
Outlines connection methods (Ethernet, GPRS) and required parameters, including SIM card PIN management.
Explains the purpose and structure of configuration and definition files.
Lists and describes the three configuration files (.ini) used for gateway setup.
Explains the role of definition files for Modbus data access and variable configuration.
Details the initial setup steps for connecting the gateway to the remote FTP server.
Guides through configuring the gateway using its web interface.
Explains how to configure the gateway's connection parameters using SMS messages.
Explains how to synchronize the gateway's time with UTC via NTP servers.
Describes the five modes for connecting to a remote server.
Details methods for forcing an immediate connection (button, web, SMS).
Explains scheduled connections based on time intervals.
Covers setting up to five specific connection times per day.
Describes automatic connection triggered by data availability.
Explains how to maintain the connection to avoid disconnections.
Covers triggering connections when an alarm is detected.
Discusses options to reduce GPRS consumption during connections.
Details scheduling data collection intervals in minutes and seconds.
Explains communication options (RS485, RS232, Ethernet) and wiring configurations.
Guides on setting up Modbus slave devices and their parameters in configuration files.
Details the format and content of definition files used for Modbus variable configuration.
Provides methods to verify Modbus device configuration and communication status.
Explains how Modbus data is collected, formatted into CSV, and uploaded.
Specifies the naming convention for uploaded Modbus data files.
Describes the structure and fields of the Modbus data files.
Illustrates Modbus data acquisition and formatting with practical examples.
Explains how Modbus alarms are triggered, recorded, and uploaded.
Details the naming convention for Modbus alarm files.
Describes the structure and fields of Modbus alarm files.
Provides examples of Modbus alarm files and their content.
Guides on using command files to write Modbus variables remotely.
Step-by-step guide for updating firmware using the built-in web interface.
Instructions for remote firmware updates using the FTP server.
Details the variables for enabling and configuring Web Services on the gateway.
Explains the structure of HTTP requests for Web Services, including parameters.
Provides examples of common Web Services requests for data upload and configuration.
Explains the gateway's event log, its upload location, and message types.
Details how to check modem status, SIM card information, and signal quality.
Describes how the unit monitors its power supply and reports status via alarms.
Specifies the naming convention for power status alarm files.
Describes the format of the 24V power loss alarm entries.
Explains the function, status, and meaning of the unit's various LEDs.
Describes the functions of the physical INSTALL button for connection or restart.
Lists SMS commands for diagnosing gateway issues and retrieving configuration.
Explains how to enable and configure debug logging for troubleshooting problems.
Provides step-by-step instructions to reset the gateway to its factory default settings.
To Next Page