Flexitron Webdyn WebdynModbus - Installation Button; Diagnostic SMS

contact@webdyn.com | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
69
10.5 Installation Button
The INSTALL button, tted on the front panel of the unit, enables forced connection or restart of the
gateway as explained in the table:
ACTION CONSEQUENCE
Press the INSTALL button for about 1 second
until the SERVICE LED ashes
Besides the actions dened in §10.3.3
Connection, the gateway uploads the inverter
parameter le.
Press the INSTALL button for about 10 seconds
until all the LEDs on the gateway go out
The gateway restarts (the LEDs light up again
about 1 minute after the restart begins)
10.6 Diagnostic SMS
Besides the conguration SMSs described in previous chapters, some SMSs can enable initial diagnosis
of a problem with the WebdynModbus:
SMS DESCRIPTION
connect Requests a connection to the remote server
version (*) Requests the current software version of the unit
reboot Initiates a restart of the product
status (*) Requests information on the current conguration of the unit:
• Unit type: WebdynPulse
• Unit identier (prexID)
• Software version
• Connection mode (GPRS or LAN)
• Information on the APN congured
• SIM card identier
• GSM signal strength (RSSI)
• Information on the Ethernet interface (IP, router, DNS, etc.)
• Information on the remote FTP server