Flexitron Webdyn WebdynModbus - Debug Traces

contact@webdyn.com | webdyn.com
V1.0 subject to changes | Webdyn © by Flexitron Group
70
diag (*) Requests diagnostics on the unit interfaces:
• DI: status of the bang-bang inputs congured
• DX: status of the index inputs congured
factory Initiates a factory reset of the unit
(*) Operational only if the option to send SMSs is enabled.
10.7 Debug Traces
Occasionally, it is necessary to enable debug traces, so as to be able to diagnose a problem. This is done
by providing values for the parameters listed below, in the conguration le prexID_cong.ini:
VARIABLE DEFINITION DEFAULT VALUE
Log_Enable Enable/Disable debugging logs:
0=Disabled
1=Enabled
Reserved for use by Webdyn in support mode
0
Log_Level Level of detail in debugging logs:
0 Emerg (emergency)
1 Alert
2 Crit (critical)
3 Err (error)
4 Warning
5 Notice (default value)
6 Info (informational)
7 Debug
Reserved for use by Webdyn in support mode
5
Log_
RemoteIpAddr
Syslog destination address
Reserved for use by Webdyn in support mode (up to 15
characters)
empty
Log_Port Syslog destination port
Reserved for use by Webdyn in support mode
2000