FlexRadio Systems FLEX-1500 Service Manual

Revision 1.0 16 Copyright FlexRadio Systems, 2010-2011
Install the front and rear panels, using the black #6 pan head screws, with a number # 6
flat washer under each screw head, with the number 2 Phillips screwdriver.
Install the two retention screws, with flat washer and lock washer on either side of the
DB-9 connector.
Fuse Replacement
The Flex-1500 contains a 3 Ampere, standard automotive type AutoFuse Mini fuse to
protect the radio in the event of an internal short, excessive power drain, or application of
power with reversed polarity to the radio. Replace with LittleFuse #297003 or
equivalent, housing color purple, 3 Ampere.
To replace the fuse, follow the “Disassembly: instructions above, and separate the two
boards.
The fuse, component designator F1, is located on the RF Power Amplifier board
immediately behind the +13.8 Volt power connector,. The fuse is a blade type fuse and is
removed by pulling the fuse away from the board. It is replaced by inserting the contact
blades into the fuse holder, and pushing downwards towards the PC board.
Reassemble the radio by following the “Re-assembly” instructions above.

FlexRadio Systems FLEX-1500 Specifications

General

Brand	FlexRadio Systems
Model	FLEX-1500
Category	Transceiver
Language	English