NOTE: The FLEX-1500 must be powered
off when you start your computer. Once
the computer has completely booted up,
then press the power button to turn on
the FLEX-1500. If the FLEX-1500 is
powered on when you start your
computer, the driver may fail to load
properly and the radio will not connect to
PowerSDR. It is a “Best Practice” to
power off the FLEX-1500 when you shut
down the computer.
Proceed to Step 4: Configure PowerSDR
on the next page.
[ The remainder of this page has been
intentionally left blank ]
To Next Page
Loading...
