Power indicator
Note: The LEDs indicate the following:
ExplanationType of signal
The camera is starting up.The LED glows continuously or-
ange.
An error has been detected. Con-
tact service.
The LED glows continuously red.
The camera has started.The LED glows continuously
green.
An error has been detected. Con-
tact service.
The LED flashes 10 times per sec-
ond.
A
Hardware reset button (for a factory default reset)
Use an unbent paper clip or a similar tool to press the reset button through
the small hole on the back of the camera for 5 seconds, then release the
button.
B
NOTE
Cables for digital I/O ports should be 100 m/328 ft. maximum.
Publ. No. T559498 Rev. a461 – ENGLISH (EN) – August 19, 2010 23
10 – Connectors, controls, and indicators
To Next Page
Loading...
Need help?
General
