FLIR A3 series - Page 25

Connectors, controls, and indicators
9
2. Power cable for 12–24 V DC power in.
NOTE
The power connector on the camera is polarity protected.
3. Digital I/O ports, opto-isolated (six-pole screw terminal).
A.Power indicator.
NOTE
The LEDs indicate the following:
B.Hardware reset button (for a factory default reset).
Use an unbent paper clip or a similar tool to press the reset button through the small
hole on the back of the camera for 5 seconds, then release the button.
#T559498; r.22370/22370; en-US
17