FLIR DM285 - THERMAL SETTINGS MENU; Thermal Display Customization

FLIR DM285 - QUICK START Document Identifier: DM285-QS-en-US_AC
Button tone
Press OK to toggle the button-press beeper ON/OFF
Battery type
Press OK to select battery type in use: Alkaline or Lithium
Language
Language
Press OK and scroll to desired language then press OK. Press Return to exit
Delete data logs
Press OK to delete all stored data logs
Delete images
Press OK to delete all stored images
Help screen
Press OK to view Customer Care contact info
View Information
Press OK to see Firmware, Lepton, Bluetooth®, and Laser icons. Press OK at the
desired icon to view its information screen
THERMAL SETTINGS MENU
Press OK to open the main menu and scroll to the Thermal Settings icon, press OK
Icon
Description
Operation
Palette
Press OK to set a thermal imager color palette (Iron, Rainbow, Gray)
Emissivity
Press OK and scroll to a preset or to the fine-tuning icon Ԑ. For fine-tuning, press OK at
the fine-tuning icon and use the arrow buttons to set value, press OK to confirm.
Laser pointer
Press OK to toggle the laser ON/OFF
Crosshairs
Press OK to toggle crosshairs ON/OFF
ADVANCED SETTINGS MENU
Press OK to open the Main Menu, scroll to the Advanced Settings icon , and press OK. Scroll to the icons shown
below and press OK to activate (blue dot next to icon indicates mode is enabled)
Icon
Description
Operation
VFD
Press OK to enable/disable the low pass filter that eliminates high-frequency noise
MAX-MIN-AVG
Press OK to enable/disable the MAX , MIN , and AVG readings
P
Peak mode
Press OK to enable/disable PEAK Max PEAK Min for ACA/ACV measurements.
Refer to the user manual for more detailed information
Relative mode
Press OK to store a reading as reference with which to compare subsequent readings.
Refer to the user manual for more detailed information
Datalogger
Press OK to start/stop logging data (up to 40k readings in 10 sets. Use Gallery mode
(Main Menu) to view logged data. Refer to the user manual for detailed information
AUTO/MANUAL RANGE
Auto range mode is the default mode of operation. When you select a new function, the starting mode is Auto range
and the indicator appears.
1. To enter Manual range mode, short press the RANGE button. Then use the RANGE button to change the range.
2. To return to the Auto range mode, long press the RANGE button.
DATA HOLD and AUTO HOLD
The meter has two HOLD modes: classic Data Hold (freezes displayed reading) and Auto Hold (advanced version of
data hold detailed in the user manual). To select Data Hold or Auto Hold as the default, please use the General
Settings menu. Press the H (HOLD) button to activate/deactivate the selected HOLD mode. In HOLD mode the H
indicator appears.