FLIR E50 Step-By-Step Guide

How to upgrade your FLIR E40 to E60 (Resolution hack)
Step-by-Step Guide:
1 Download Flir Tools or drivers from www.flir.com
2 Install FLIR Tools on to your computer (If this applies)
3 Turn on your Flir E30, E40 or E50 Camera
4 Connect your Flir camera to your computer using the USB-Cable, and let windows install the
needed drivers.
5 After windows has completed installing all drivers, disconnect your camera from the USB-Cable
6 Press navigation pad/button (2) with a push in the center “The menu system bar will appear”
7 From the menu system bar select push left on the navigation pad to toggle to Settings/Options
(11)
8 Press navigation pad/button (2) with a push down to enter “ Settings”
9 Press navigation pad/button (2) with a push down to scroll down to “ Device settings”
10 Press navigation pad/button (2) with a push right to enter “ Device settings menu”
11 Press navigation pad/button (2) with a push down to scroll down to “ Camera Information”
12 Press navigation pad/button (2) with a push right to enter “ Camera Information menu”

FLIR E50 Specifications

General

Resolution	240 x 180 pixels
Image Storage	SD card
Focus	Manual
Image Frequency	60 Hz
Accuracy	±2°C or ±2% of reading
Digital Camera	3.1 MP
Digital Zoom	4x continuous
Measurement Presets	Yes
Laser Pointer	Yes
Battery Operating Time	4 hours
Spectral Range	7.5 – 13 µm
Operating Temperature Range	-15°C to +50°C
Storage Temperature Range	-40°C to +70°C
Thermal Sensitivity	<0.05°C at 30°C
Field of View	25° × 19°
Temperature Range	-20°C to +650°C
Display	3.5" LCD touchscreen
Image Modes	Thermal, MSX
Battery Type	Li-Ion battery
Weight	0.825 kg