1. Camera screen
2. Archive button
• Push to open the image archive.
3. Navigation pad
• Push left/right or up/down to
navigate in menus, submenus, and
dialog boxes.
• Push the center to confirm.
4. Cancel button
• Push to cancel a choice.
• Push to go back into the menu
system.
5. On/Off button
• Push and hold the button for less
than 5 seconds to put the camera in
standby mode. The camera then
automatically turns off after 48
hours.
• Push and hold the button for more
than 10 seconds to turn off the
camera
The purpose of this USB mini-B connector is the
following:
• Charging the battery using the FLIR power supply.
• Charging the battery using a USB cable connected to
a computer. Note Charging the camera using a USB
cable connected to a computer takes considerably
longer than using the FLIR power supply or the FLIR
stand-alone battery charger.
• Moving images from the camera to a computer for
further analysis in FLIR Tools. Note Install FLIR
Tools on your computer before you move the images.
To Next Page
Loading...
