FLIR Elara DX Series - Supplying Power to the Camera

This document does not contain any export-controlled information.
Installation
9
427-0300-00-12 - Revision 110 - May 2021
Connector
Connection
2
LAN
Attach a Cat 5e or Cat 6 cable from the network switch to
the RJ45 LAN connector for a 10/100/1000 Mbps Ethernet
and PoE connection. For information about using PoE, see
Supplying Power to the Camera. Verify that the LAN
connector LEDs are steady green and flashing yellow.
3
AC24V IN
If using a 24 VAC power supply, connect its wires to the
three-pin power terminal block. See pin assignment below.
4
14-pin terminal
block
Attach wires from external devices to the 14-pin terminal
block connector for alarm and audio in/out (see diagram
and definitions below).
14-Pin Terminal Block
Pin
Definition
Pin
Definition
1
Audio-Out
8
Not used
2
Ground (Audio I/O)
9
Alarm-In 4
3
Alarm-Out A1
10
Alarm-In 3
4
Alarm-Out A2
11
Alarm-In 2
5
Alarm-Out B1
12
Alarm-In 1
6
Alarm-Out B2
13
Ground (Alarm I/O)
7
Not used
14
Audio-In
AC24V IN Connector
Pin
Definition
1
AC 24L
2
Ground
3
AC 24N
Warning
This product contains a battery that is soldered to the PCB. There is a risk of explosion if the battery is
replaced by an incorrect type. Do not replace the battery. The battery should be disposed of in
accordance with the battery manufacturer’s instructions.
2.4 Supplying Power to the Camera
The camera can be powered by PoE or an external 24 VAC power supply (not included in the camera
kit).
· If using PoE, make sure the PoE switch or injector is a Power Sourcing Equipment (PSE) device.
· If using a PoE-capable network switch, the switch needs to support Universal PoE 60W 4 pair forced
mode. For information regarding recommended switches, contact FLIR Support. Note: The camera
does not support CDP/LLDP.
· If using a PoE injector, use a FLIR CP-POE-4P-60W-xx injector or contact FLIR Support for information
about compatible injectors.
· If using an external AC power supply, connect the power supply's wires to the power terminal block.