This document does not contain any export-controlled information.
Configuration
51
427-0300-00-12 - Revision 110 - May 2021
o P&T Start Tour—If a tour is defined on PTZ Page, initiates a tour of pan and tilt preset positions.
o P&T Stop Tour—If a tour is defined on PTZ Page, stops the tour of pan and tilt preset positions.
4.9 Firmware & Info Page
On the Firmware & Info page, you can:
·
Specify a unique name for the camera
·
Upgrade the camera's firmware
·
Reset the camera to its factory defaults
·
Reboot the camera
·
Define a log level and download system information
·
Enable the compatibility mode for legacy VMS versions
Name
Specify a unique, friendly name for the camera, using only alphanumeric characters. The default name
for the camera is the camera model followed by the camera’s serial number.
To upgrade the camera's firmware:
1. Make sure the camera has been recently rebooted.
2. Under Upgrade version, click Find file.
To Next Page
Loading...
