3 EN-US English
8. Autofocus the camera by pushing the center of the
button.
9. Push the
button.
10. Move the joystick left/right to the Edit tab.
11. Move the joystick up/down to Add spot.
12. Push the joystick. A spotmeter is now displayed in the middle of the screen.
The temperature is displayed in the result table in the top left corner of the
screen.
13. To save an image directly, push and hold the
button for more than one
second.
14. To move the image to a computer, do one of the following:
• Remove the SD Memory Card and insert it in a card reader connected to
a computer.
• Connect a computer to the camera using a USB mini-B cable.
15. Move the image from the card or camera, respectively, using a drag-and-
drop operation.
3.6.2 Detecting a gas leak
1. Charge the battery for four hours, or until the green battery condition LED
glows continuously, before starting the camera for the first time.
Note Do this at room temperature, with the camera turned off.
2. Insert an SD Memory Card into a card slot.
3. To turn on the camera, push the
button.
Note When you turn on the camera, a mechanical cooler will begin cooling
down the infrared detector. The cooler has a sound that resembles a sub-
dued motor. This sound is normal. The cooling procedure will typically take 7
minutes for FLIR GF300, FLIR GF309, FLIR GF320, and 10 minutes for FLIR
GF306. In high ambient temperatures the cooling times may increase 30%
or more.
4. Turn the mode wheel to
.
#T810142; r. AB/55671/55671; mul 6
To Next Page
Loading...
Need help?
General
