EN-US English
Menu system
1. Menu system
1. Battery indicator
2. Measurement result
2. Power supply cable
3. Power indicator
4. Date and time
Quick Start Guide
5. Limit value for the temperature scale
Follow this procedure to start
6. Temperature scale
immediately:
7. Currently set emissivity value or ma-
terial properties
1. Remove the protective film from the
8. Current function for the right selection
LCD.
button
2. Insert a miniSD™ Memory Card into
9. Current function for the left selection
the card slot.
button
How to charge the battery
You must charge the battery inside the
camera for four full hours (or until the
battery indicator displays a green light)
before you use the camera for the first
time.
Charge the battery by connecting the
power supply to the power connector on
3. Push the On/Off button to turn on the
the camera. Note: The first time you
camera. Note: If the camera does not
charge a factory-new battery you must
start, push the reset button with a
turn on and then turn off the camera after
non-conductive tool. The reset button
you have connected the power supply to
is located beside the battery connec-
the power connector on the camera.
tor, inside the battery compartment.
Then push the On/Off button again.
4. Open the lens cap by pushing the
lens cap lever.
© 2011, FLIR Systems, Inc. All rights reserved worldwide.
20
Publ. no. T559526, rev. 001
To Next Page
Loading...
