IDENTIFINDER
®
R200 – Quick Start Guide
Press to display the spectrum.
To exit the identification mode and return home press .
FINDER MODE
IDENTIFICATION MODE
DOSE RATE MODE
In Dose Rate Mode, the instrument is measuring the
gamma dose rate and will automatically alert the
operator when there is a significant change in ambient
dose rate level or when an alarm threshold is breached.
Press & hold
Power button
until splash
screen appears
Wait until instrument
completes initialization
(<30 seconds)
Dose Rate Mode (Home)
appears automatically
following initialization
FLIR splash screen
(Default Mode)
In Finder Mode, the instrument can be used to localize
the source of an elevated dose level. If Finder Mode is
not needed, skip to Identification Mode by pressing:
Press to
enter Finder Mode.
Wait while background baseline is established
(10 seconds). The R200 will then automatically
enter Finder Mode. Bars indicate increased or
decreased activity levels during search.
Once source is
located, press
to identify source.
https://flir.pw/r200
TURN IDENTIFINDER R200 ON
You are now actively operating the unit as a Personal Radiation Detector.
Dose Rate Mode
(Home)
Radiation Detected
(Alarm)
Current Dose Rate
(Analog)
Mute Alarm
Acknowledge Alarm
Dose Rate Reading
and Units (Digital)
May also be
displayed in Sieverts
After alarm, proceed to Finder
Mode or Identification Mode.
Once source is
detected or located,
press to enter
Identification Mode.
Proceed to Identification Mode.
The Magic Eye and on-screen prompts will guide you to maintain
optimum distance from source. Screen shows % complete or time
remaining for data collection. Instrument automatically analyzes
data when collection is complete.
In this mode, the R200 collects
data & analyzes it to determine the
identification of the source nuclide(s).
4.6x6.1_R200_QSG_022216.indd 4-5 2/24/16 4:57 PM
To Previous Page
Loading...
