Need help?Do you have a question about the FLIR identiFINDER R200 and is the answer not in the manual?
General| Energy Range (Gamma) | 30 keV to 3 MeV |
|---|---|
| Isotope Identification | Yes |
| Display | Color LCD |
| Battery Life | Up to 24 hours |
| Ingress Protection | IP67 |
| Radiation Detection | Gamma |
| Dose Rate Range | 0.01 µSv/h to 10 mSv/h |
| Weight | 1.5 kg |
| Operating Temperature | -20°C to +50°C |
Essential warnings for operating the FLIR identiFINDER R200, including housing integrity and power connection safety.
Steps to reset the FLIR identiFINDER R200 to its factory default settings, including password reset.
Detailed guide on powering the FLIR identiFINDER R200 on/off and performing instrument checks.
How to use the FLIR identiFINDER R200 in Dose Rate Mode to observe and measure radiation in the environment.
Using "Finder Mode" to locate radiation sources, including background measurement and source detection.
Using "Identify" mode to determine the specific nuclides present from a detected radiation source.
Methods for connecting the FLIR identiFINDER R200 to a computer for data transfer and communication.
Explanation of the "Dose Rate" mode, its display, units of measure, and meter readings.
How to set warning and alarm thresholds for Dose Rate, Dose, and Sigma values.
Details on using "Finder Mode", including background measurement and control limits for source detection.
Procedure for using "Identify Mode" to determine radiation source nuclides and interpret results.
Setting and understanding Gamma alarms for Dose Rate, Dose Threshold, and Sigma.
Explanation of Sigma Alarms, standard deviation, and how they relate to radiation fluctuations.
Details on configuring the FLIR identiFINDER R200 via its web interface, including device settings.
Detailed procedures for charging the FLIR identiFINDER R200 battery via wall outlet or computer.
To Next Page
