FLIR identiFINDER R200 - Preparing the USB Network Connection on a Computer; Using the Network Connection

6.3 Preparing the USB Network Connection on a Computer
6.3 Preparing the USB Network Connection on a Computer
The FLIR identiFINDER R200 is designed to work with Microsoft Windows 7 and later.
If the FLIR identiFINDER R200 is NOT set to MSD (Mass Storage Device) mode, then connect to a com-
puter and communications may be established with the detector by typing "r200.flir"into the address bar
of the user's preferred browser (Mozilla Firefox
®
, Google Chrome
®
, or Microsoft Internet Explorer (IE)
11
®
, or above).
Some computers may be configured (e.g., security, access privilege, etc.) in a manner in which
USBdrivers do not load, or load improperly and will require technical support.
Drivers for the FLIR identiFINDER R200 are supplied on the USBthumb drive (memory
stick)included, or may be obtained at http://www.Detectionsupport.com/radiation .
6.4 Using the Network Connection
Please take note of the serial number printed on the back of the detector. It is sometimes
used to identify the FLIR identiFINDER R200 in a computer network. This is also useful for
user's requiring customer support from FLIR.
Networking is accomplished by a physical connection using the USBcable, or by pairing the FLIR
identiFINDER R200 with other devices using Bluetooth.
R200 3/10/2017__1:38 PM 6–76