2.4 Startup
2.4 Startup
To start the FLIR identiFINDER R200, press the power button.
The FLIR logo displays during the boot-up sequence, followed (briefly) by the "Initializing" screen.
After this sequence, the FLIR identiFINDER R200 will be at the home page (Dose Rate mode).
Figure 2-13 The Start-up sequence; splash, initialization (including firmware build)and then the Dose
Rate mode.
Start-up, boot-up, initialization, or "splash" screen. This displays just after turn-
ing the FLIR identiFINDER R200 on (press the power button ( ) until this
screen displays) while the firmware is loading into memory.
An "Initialization" screen displays and returns information concerning the pro-
gress, Firmware build, available memory and detector type.
After the system initializes (boots), then the Dose Rate screen immediately dis-
plays.
This mode displays the battery life icon (upper-left of Title bar), the time (upper-
right); and on the central display ("Desktop") is the Dose Rate, which is
2-46 R200 3/10/2017__1:38 PM
To Next Page
Loading...
