FLIR identiFINDER R200 - 3.5 Transfer, Connection and Communication with a Computer

3.5 Transfer, Connection and Communication with a Computer
3.5 Transfer, Connection and Communication with a Computer
The method for interface with a local computer is achieved by porting to a USB2.0 connection on the computer that
the FLIR identiFINDER R200 is connected to via its charging/data transfer port.
Figure 3-9 Connection port (USB 2.0 Mini B) for charging and data transfer is located behind the port cover at the
base of the detector. Note the orientation of the cabling connector (wide-side of the connector is imprinted with the
USBsymbol and is aligned with the face (top) of the detector); this is to ensure proper docking with the port.
The opposite end of the cable is a standard USBconnection, and should be connected to the computer.
3.5.1 FLIR identiFINDER R200 Connection Settings
The FLIR identiFINDER R200 may be set to either connect as a Mass Storage Device (MSD), or in nor-
mal operating mode when the MSDmode is set to "OFF". For the Web Interface "Preparing the USB Net-
work Connection on a Computer" on page76 to connect the FLIR identiFINDER R200 and an external
device (for example, a computer).
Figure 3-10 Navigate to "MSD" to control Mass Storage Device.
3-55 R200 3/10/2017__1:38 PM