FLIR identiFINDER R200 - Indicators; Records

serialcommunication to "OFF".
Additionally, selections are provided for the USBSubnet (as follows):
l 172.*
l 192.*
l 10.*
The grey highlight box controls this selection on the FLIR identiFINDER R200.
Indicators
In this section of the "Device"menu, settings are provided for the Key Tone, Key Vib, Alrm Tone,
Alrm LED, Alrm Vib and HdPh Vol.
Select the following check boxes with a check to turn a function to "ON", and clearing the box
sets the feature to "OFF"on the FLIR identiFINDER R200:
l Key Tone sets an audible tone when keys are pressed on the detector,
l Key Vib sets vibration on the keys,
l Alrm Tone sets an audible tone for alarms,
l Alrm LEDsets the visual signal on the LED (red GAMMA LED, left of Thumbpad),
l Alrm Vib sets the vibration function on the unit on or off.
The "HdPh Vol" field is used to set the headphone volume on the FLIR identiFINDER R200, and
is expressed as a percentage and scales from 10% to 100% volume.
Records
In this section of the "Device"menu, the user is able to record the "Operator"(user) responsible
for the FLIR identiFINDER R200, and a callback number to reach the user responsible for the
detector.
7 - 79 R200 3/10/2017__1:38 PM