FLIR identiFINDER R200 - 6.2 As a Mass Storage Device

6.2 As a Mass Storage Device
6.2 As a Mass Storage Device
6.2.1 FLIR identiFINDER R200 Connection Settings
The FLIR identiFINDER R200 may be set to either connect as a Mass Storage Device (MSD), or when
the MSDmode is set to "OFF"connected in normal operating mode (exit the MSDmode to disable). The
USBcable provides the hard-wire connection for the Web Interface (see Web Server " Using the
Web Server" on page77) to securely integrate the FLIR identiFINDER R200 with an external device (for
example, a computer.).
Figure 6-2 Navigate to "MSD" and exit it to turn off the Mass Storage Device. "USBCOM" should be set
to "ON".
Figure 6-3 Selecting the circled checkmark at this point will set the detector to Mass Storage Device
(essentially a thumb drive )which the user may navigate through a file explorer from the computer.
Navigate here {Device / Connect / USB / MSD} to change the interface settings so that the detector is set
with the Mass Storage disabled.
Selecting "circle X" will disable.
R200 3/10/2017__1:38 PM 6–74