3.5.1 FLIR identiFINDER R200 Connection Settings
Figure 3-11 Selecting the circled checkmark at this point will set the detector to Mass Storage Device
enabled (essentially a thumb drive which the user may navigate through a file explorer from the com-
puter). Selecting the circled "X" here will exit Mass Storage Device and reset full functionality of the
detector.
Navigate to {Device / Connect / USB / MSD} to change the interface settings so that the detector is set
with the Mass Storage disabled by selecting the circle "X" command
.' Reboot to confirm setting.
Figure 3-12 USB COM on/off only
affects serial communication and
does not affect mass storage or
web interface operation. Device
needs to be re-booted to reset
USBstate to on or off.
When the FLIR identiFINDER R200 is connected via the USBcable,
use a web browser from the PC (Microsoft IE 11 and up, Google
Chrome, Mozilla Firefox), type "r200.flir" into the browser address
field to display the web interface in the browser.
R200 3/10/2017__1:38 PM 3–56
To Next Page
Loading...
