Floe PWC1300 - Attach Frame Beams to Side Frames

STEP 1
• POSITION THE FRAME BEAMS ONTO THE SIDE FRAMES AS SHOWN (FIGURE 1.6). NOTE THAT THE FRAME
BEAMS ARE PLACED ON THE OUTERMOST SIDE OF THE TABS ON THE SIDE FRAME BEAMS (FIGURE 1.7).
• SLIDE THE FRAME BEAM CLAMPS ONTO EACH END OF BOTH FRAME BEAMS (FIGURE 1.8).
IMPORTANT:
BE SURE THAT THE
DRAINAGE HOLES IN THE
FRAME BEAMS ARE ON
THE BOTTOM AT TIME OF
INSTALLATION
FIGURE
1.6
FIGURE
1.7
4X
FIGURE
1.8