Floe V-2602 - Safety and Assembly Guidance; Assembly Diagram Symbols; Important Assembly Warnings; Helpful Assembly Tips

IMPORTANT NOTE:
DO NOT USE IMPACT WRENCH
WHEN ADJUSTING THE EASY
LEVEL LEGS
Warnings
Tips

Torque nuts to specification, not bolts.
 Place parts and fasteners in designated locations prior to each step.
 Before tightening fasteners to specified torque, ensure that the lift is square.
 Measure from corner to corner (A to C/B to D) to verify that the lift is square.
 Measure distance between corner posts (A to B, B to C, C to D, A to D) above frame beam and at
the top of the corner post to verify that the lift is square.
 Ensure that the lift is level and square before proceeding to install the V-Brace.
 Assemble cradle clamps with given bolt and nut before installing onto cradle beam.
 Use a marker to denote fasteners which have been tightened to the specified torque.

Read instructions and understand them before attempting assembly.