Floe VSD 6000 - Page 29

29
STEP 4
-ATTACH ACTUATORS
PLACE ACTUATORS INTO UPPER AND LOWER BRACKETS (FIG.1 AND FIG.2). ATTACH
USING 3/8-16 x 2 ½” BOLTS AND 3/8-16 NYLOCK NUTS (FIG.1 AND FIG. 2).
ACTUATOR MOTORS MUST FACE TOWARDS INSIDE OF LIFT AS SHOWN BELOW.
ACTUATOR MOTORS MUST FACE TOWARDS INSIDE OF LIFT AS SHOWN BELOW.ACTUATOR MOTORS MUST FACE TOWARDS INSIDE OF LIFT AS SHOWN BELOW.
ACTUATOR MOTORS MUST FACE TOWARDS INSIDE OF LIFT AS SHOWN BELOW.
PLACE A SPACER BETWEEN THE CANOPY RAIL GUIDE AND CANOPY LEG TO ENSURE A
¼” GAP (FIG. 3).
ALIGN ACTUATOR TO DIMENSIONS SHOWN (FIG.4). TORQUE LOWER
TORQUE LOWER TORQUE LOWER
TORQUE LOWER NON
NONNON
NON-
--
-PIVOTING
PIVOTING PIVOTING
PIVOTING
BRACKET NUTS TO 20
BRACKET NUTS TO 20BRACKET NUTS TO 20
BRACKET NUTS TO 20 FT/LBS.
FT/LBS.FT/LBS.
FT/LBS. TIGHTEN ACTUATOR BRACKET NUTS UNTIL NYLOCK IS
TIGHTEN ACTUATOR BRACKET NUTS UNTIL NYLOCK IS TIGHTEN ACTUATOR BRACKET NUTS UNTIL NYLOCK IS
TIGHTEN ACTUATOR BRACKET NUTS UNTIL NYLOCK IS
PIERCED.
PIERCED.PIERCED.
PIERCED.
FIG. 1