OPERATING INSTRUCTIONS
17
Step 4: Release transport / Teflon belt
Same steps for transport as for Teflon belt:
Push the upper hinder guiding roll toward the one in
the front against the spring,
and release the tension for the transport belt.
Remove the slackened transport belt
Step 5: Insert new transport / Teflon belt
Same steps for transport as for Teflon belt:
Place the new belt over the hinder transport roll,
push the roll toward the roll in the front
place the belt over the front roll and loosen the
pressure
Gently turn the rollers to check whether the belt is
situated correctly between the seal pads. The belt
should be able to move free.
To Next Page
Loading...