FLORABEST 79822 - Operation;Programming; General Information; Programming the Appliance

13
FBC 7 A1
GB
IE
Operation/Programming
In this chapter you will receive important information about the
operation and programming of the appliance.
General information
■ By pressing the button M
3
you activate the programming
mode.You can either carry out all settings in succession or,
by repeatedly pressing the button M
3
, switch between the
following setting options:
― System time (actual time/weekday)
― Water fl ow in %
― Time for the next watering
― Duration of the watering
― Watering interval
― Standby (Programming mode terminated and watering
programme active).
■ After about 1 minute without input the appliance returns to
standby mode.All values already programmed are retained.
■ By pressing the button ON/OFF
5
the programming mode can
be terminated at any time. All values already programmed are
retained.
Programming the appliance
System time (
A
)
♦ Press the button M
3
once. The hour indicator and the clock
symbol blink.
♦ Using the rotary knob
2
enter in the required value and press
the button
4
. The minute indicator and the clock symbol
blink.
IB_79822_FBC7A1_LB3.indb 13IB_79822_FBC7A1_LB3.indb 13 14.12.12 13:5114.12.12 13:51