FLORABEST FRMA 36/1 A1 User Manual (English)

Questions and Answers:

K
Kenneth WallsAug 2, 2025
What to do if my FLORABEST Lawn Mower doesn't start?
- E
  Emily FletcherAug 2, 2025
  If your FLORABEST Lawn Mower doesn't start, there are several potential causes: * The rechargeable battery may be discharged. In this case, check the charge status and charge the rechargeable battery. * The rechargeable battery may not be inserted, so insert the rechargeable battery. * The grass may be too long. Set a greater cut height and lift the front wheels slightly by pressing down on the bow-type handle. For defective release button or start lever, repair by customer services. If the carbon brushes are worn or the motor is defective, further action is needed.
A
Alan WaltersAug 8, 2025
Why is my FLORABEST Lawn Mower motor stopping?
- L
  Lauren MillerAug 8, 2025
  If the motor of your FLORABEST Lawn Mower stops, it might be due to a blockage by a foreign object. Remove the foreign object to resolve this issue.
J
Joseph JohnsonAug 14, 2025
Why FLORABEST FRMA 36/1 A1 has strange noises, rattling or vibrations?
- C
  Crystal KennedyAug 14, 2025
  Strange noises, rattling, or vibrations in your FLORABEST Lawn Mower can be caused by a loose blade screw or a damaged blade. Try tightening the blade screw. If the issue persists, replace the blade.
J
Johnny TorresAug 19, 2025
What to do if FLORABEST FRMA 36/1 A1 Lawn Mower result is unsatisfactory or motor labours?
- M
  Misty SparksAug 20, 2025
  If you find the result unsatisfactory or the motor labours on your FLORABEST Lawn Mower, consider these possible causes: * The cut height may be too low. Set a higher cut height. * The blade may be blunt. Have the blade sharpened or replace it. * The blade area may be blocked. Clean the equipment. * The blade may be assembled incorrectly. Install the blade correctly.
J
Jose LeeAug 27, 2025
How to fix a FLORABEST FRMA 36/1 A1 blade that fails to turn?
- D
  Daniel SmithAug 27, 2025
  If the blade of your FLORABEST Lawn Mower fails to turn, it could be due to the blade being blocked by grass. Remove the grass to clear the blockage. Alternatively, the blade screw may be loose. Tighten the blade screw to secure the blade.