16
WARNINGS
• Do not use excessive force. If something is stuck, try repeated gentle
movements until it loosens. If it’s still stuck, contact us
• Do not bend the Flow Frame. This may cause the frame to fall apart.
In the event that your frame falls apart it can be reassembled.
See www.honeyflow.com for further instructions
• Do not expose the frames to direct sunlight for long periods
• Do not expose the frames to extreme heat (once inside an operating
hive, the bees will keep the temperature consistent)
• Do not use chemical solvents that are not recommended. See the FAQs
on honeyflow.com for recommendations
• Do not use a blow torch or flame device on frames
• Refer to our website for up to date irradiation information.
Following these recommendations will greatly extend the useful life of your
Flow Frames.
To Next Page
Loading...
