flowair T-box - Page 18

82 83www.owair.com
heater activated for operation in
destratication mode
activation of destratication mode
setting of temperature dierence (dierence
between temperature under the ceiling and
temperature in the occupied zone), at which
LEO heaters will be turned on
selection of heaters, which should operate in
destratication mode
LEO heaters can optionally operate in destratication
mode (only heaters installed under the ceiling). When
the measured temperature drops to the set temperature
only fan starts. When the heat under the ceiling is not
enough, and the temperature continues to decline
(-1
o
C from the setpoint) valve will open.
The heater must be equipped with T3 sensor (optional
equipment).
Destratication
DestraticationDestratication