69www.owair.com
POLSKIENGLISHРУССКИЙNEDERLANDS
12:55PM
Devices
Check that all devices have been found. If not, check:
• correctness of connection of the A-A, B-B communication signal,
• power connection of the device,
• if address have been set correctly; each device must have a dierent address set, (in Cube devices the address is set by
the service during the rst start-up)
• if the SW2 dipswitch on the last device in line is set to T120 position. (in Cube devices, the dipswitch is set by the
service during the rst start-up)
Setting of desired temperature.group of devices
water heater
gas heater
electric heater
destraticator
ventilation unit
rooftop units
water heater with
mixing chamber
gas heater with
mixing chamber
air curtain-fan heater
combo unit
air curtain
device no 8 in LEO
group
LEO
LEO KM
LEO
EL
DUO
LEO
D
ELiS
OXeN
Cube
ROBUR
ROBUR
KM
fan cooler / heater
air curtain
LEO
COOL
Slim
To Next Page
Loading...
Need help?
General