10 Instruction Manual
START PROGRAMMING - Press MENU
Main Menu
The Main Menu consists of Batch? (if selected), Password?, Change?, Units?, Menu-1,
Menu-2, and Save & exit
Batch?
M-no S-yes
(only displayed if option selected)
Press M to continue or S to enter the Batch Menu.
Password?
****
Enter the required password. The flowmeter is shipped with the password 1000. (Default
password = 1973). The set-up can be viewed without the password, however, no changes
can be saved at the Save & exit menu item and the error message wrong password is
displayed.
Press ► repeatedly until cursor is under digit to be edited
Press ▲ repeatedly until desired value is displayed and M to continue
Change ?
1000
Provided the correct password was entered, a new password can now be entered. Enter the
required password.
Press ► repeatedly until cursor is under digit to be edited
Press ▲ repeatedly until desired value is displayed
Press M to continue
Units?
Metric
Metric and US units of rate and total measurement are available.
Press ▲ until desired units are displayed and M to continue.
Menu-1
M-cont S-enter
Press S to enter or M to continue
Menu-2
M-cont S-enter
Press S to enter or M to continue
Save & exit
M-cont S-yes
Press S to save and exit or M to continue
Cal mode
M-cont S-enter
Press S to enter or M to continue (Cal mode is a hidden menu), see page 14.
To Next Page
Loading...
Need help?
General