FLTR PC828 - Set High Temperature Alert Threshold; Replace Batteries

Set Threshold for High Temperature Alert (Red Indicator)
This thermometer has 100.4°F (38.0°C) preset as the threshold to
indicate a high temperature. However, this is only a reference value. At
this temperature, dierent people feel dierent, with some feeling bad
and others feeling not as bad. If you wish to change the high tempera-
ture threshold aer consulting with your doctor, you can manually
adjust it to suit your preference.
With the thermometer o, hold the Measurement Trigger for 15 seconds
until you see the Red Temperature Indicator on the digital display,
then release the trigger.
Press the trigger again to increase the threshold by .02°F (0.1°C). Press
again and again as needed. The adjustment range is from 100.4 – 102.0°F
(38.0 – 38.9°C). Once you reach maximum threshold temperature, press
the trigger again and it will return to the minimum value and the cycle
will repeat.
Aer adjustment is complete, press the trigger for 5 seconds to save the
setting and turn the thermometer o.
Shut down
When the thermometer is turned on, it will shut down automatically
when it is not used for 30 seconds. You can also hold the Measurement
Trigger for 5 seconds to shut down the device manually.
Replace batteries
When the Low Battery Indicator appears on the screen, it is time
to replace the batteries. Slide open the Battery Cover, remove the
batteries and insert 2 x AAA batteries (included) into the battery
compartment correctly according to the polarity symbols marked on the
device. Close the battery cover and thermometer will be restored for
normal use.
Note: Thermometer requires 2 x AAA batteries to operate. Included.
- 12 -
! Take out the batteries if the thermometer will not be used for
one month or more.