fluidra Astral Pool E35 - Salt Level and Maintenance; Salt Level Guidelines

INST 385 E35 SALT CHLORINE GENERATOR (10-2018)
7
SALT LEVEL
Salt Level in ppm
Pool Volume (litres)
3,200 ppm
50,000 – 85,000 L
4,600 ppm
85,000 – 120,000 L
6,000 ppm
120,000 – 160,000 L
Initial dosage
We recommend adding 3.2 kg of salt for every 1,000 L of water.
Although salt is not consumed by the E35 Salt Chlorine Generator, salt is lost during backwashing, and rinsing of the
sand filter. A low salt level warning is indicated on your E35 Salt Chlorine Generator if the salt level drops. If LOW SALT
is indicated, check again in 24 hours and then if it is still indicated, add 25 kg (50 lb) of salt to the shallow end of your
pool. Run the filtration system for approx. 6 hours to help mix the salt in the pool. It can take up to a day for the salt to
fully dissolve.
If the LOW SALT light is still on, have the salt level of your pool water tested at your nearest retailer. If the result of the
in-store test indicates a salt level greater than 3,200 ppm, have your Salt Chlorine Generator checked.
WARNING: Never add salt directly to the skimmer box. This practice should
be avoided as it allows very high concentrations of salt to be passed through
your filtration and other pool equipment.