Clamp Meter
Safety Information
3
• Carefully read all instructions.
• Hold the Product behind the tactile barrier. See The Clamp Meter,
item .
• Do not use test leads if they are damaged. Examine the test leads
for damaged insulation or exposed metal. Check test lead
continuity.
• Do not measure current while the test leads are in the input jacks.
• Do not use the Product around explosive gas, vapor, or in damp or
wet environments.
• Limit operation to the specified measurement category, voltage, or
amperage ratings.
• Do not work alone.
• Do not apply more than the rated voltage, between the terminals or
between each terminal and earth ground.
• Comply with local and national safety codes. Use personal
protective equipment (approved rubber gloves, face protection, and
flame-resistant clothes) to prevent shock and arc blast injury where
hazardous live conductors are exposed.
To Next Page
Loading...
