Fluke 30800001 - Specifications and Compliance; Line Cord Replacement and Accessories; Technical Specifications

6
TS30 Test Set
Users Guide
Line Cord Replacement
The line cord can be replaced by the user. To replace
the line cord refer to the instructions that come with
the replacement line cord. To obtain a replacement line
cord contact your local distributor or Fluke Networks.
Accessories
To order accessories, contact your local distributor or
Fluke Networks.
Specifications
Description
Fluke Networks
Model Number
Angled Bed-of-Nails Cord (ABN) P3080009
Load Coil Standard Line Cord
(STD) with Piercing Pin Clips
P3080001
Belt Clip P3218350
Electrical
Return Loss >14 dB (ref 600 )
Line Current Range 15 mA to 120 mA
Resistance to
Continuous Current
(Talk Mode)
275 typical at 20 mA
Monitor Mode
Impedance
>120,000 
300 Hz to 3400 Hz
Pulse Dial Output
Pulsing Rate 10 pps +
1 pps
Open/Close Ratio 60/40
Inter-digit Interval 800 ms +20 %, -10 %
Resistance During
Pulse Open
> 200,000 
Protection Against
Alternating Current
Overvoltage
The TS30 survives up to
300Vpk across its test
leads.
Protection Against
Transient Voltages
The TS30 survives up to
1500 V across its test
leads.
DTMF Output
Tone Frequencies
Tone Frequency Error
per ITU-T Q.23
±1.5% maximum
Tone Level
High Group
Low Group
-4 dBm +
2 dB (into 600 )
-6 dBm +
2 dB (into 600 )
High vs Low Tone
Difference
2dB +
1db
Last Number Redial
(Tone/Pulse)
Memory Capacity
Memory Retention
23 digits
8-minutes nominal
Flash Duration 600 ms ±100 ms
Ringer Loudness > 70 dBA at 1 meter
Ringer Equivalent (REN) 0.14
Peak Acoustic Output
of the Receiver
<120 dBspl
Maximum Sound Level
from the Receiver
125 dB(A) above 20 μPa
for less than 1 second
Physical
Measurements 10 in x 2.83 in x 3.34 in
(25.5 cm x 7.2 cm x 8.5
cm)
Weight 16.8 ounces (0.476 kg)
Environmental
Temperature
Operating
-4 °F to +140 °F
(-20 °C to +60 °C)
Storage -40 °F to +151 °F
(-40 °C to +66 °C)
Altitude To 3,000 m (10,000 ft)
maximum
Relative Humidity 5 % to 95 %
(non-condensing)