Need help?Do you have a question about the Fluke 725Ex and is the answer not in the manual?
Details how to measure voltage or current using the upper display.
Describes how to measure current using the calibrator's internal 12-V loop power supply.
Provides instructions for attaching thermocouples and selecting types for measurement.
Details how to select and set the current sourcing mode.
Explains how to simulate a transmitter by providing a settable test current in a loop.
Details how to measure voltage or current using the upper display.
Describes how to measure current using the calibrator's internal 12-V loop power supply.
Provides instructions for attaching thermocouples and selecting types for measurement.
Details how to select and set the current sourcing mode.
Explains how to simulate a transmitter by providing a settable test current in a loop.
General| Safety Rating | Intrinsically Safe |
|---|---|
| Power Supply | Four AA alkaline batteries |
| Operating Temperature | -10°C to 50°C |
| Voltage DC | 0 to 30 V |
| Current DC | 0 to 24 mA |
| HART Communication | Yes |
| Intrinsically Safe | Yes |
| Voltage Range | 0 to 30 V |
| Current Range | 0 to 24 mA |
| Storage Temperature | -20°C to 60°C |
| Type | Process Calibrator |
| Measurement Functions | Frequency |
| Source Functions | Frequency |
| Display | LCD |
| Loop Power Supply | 24 V |
| Thermocouple Types | J, K, T, E, R, S, B, N |
| RTD Types | Pt100, Pt200, Pt500, Pt1000, Cu10, Cu50, Cu100, Ni120 |
| Pressure | Requires pressure module |
| Pressure Range | Depends on pressure module |
| Frequency Range | 0 to 10 kHz |
| Communication Interface | HART |
| Safety Certification | ATEX, CSA |
| Dimensions | 130 mm x 236 mm x 61 mm |
| Voltage DC Accuracy | ±(0.02% + 2 counts) |
| Current DC Accuracy | ±(0.02% + 2 counts) |
To Next Page
