Fluke 725Ex - Approved Batteries; Maintenance; Cleaning the Calibrator; Service Center Calibration or Repair

725Ex
Users Manual
50
Approved Batteries
Table 8. Approved Batteries
Battery Manufacturer
(All Batteries Alkaline- AA 1.5 V)
Type
Duracell MN1500
Eveready (Energizer) E91
Panasonic Powerline LR6A
Rayovac 815
Varta 4906
Ucar Gold LR6
Maintenance
Cleaning the Calibrator
W Warning
To avoid personal injury or damage to the
Calibrator, use only the specified replacement
parts and do not allow water into the case.
W Caution
To avoid damaging the plastic lens and case, do
not use solvents or abrasive cleansers.
Clean the Calibrator and pressure modules with a soft
cloth dampened with water or water and mild soap.
Service Center Calibration or Repair
Calibration, repairs, or servicing must be performed only
by qualified service personnel. If the Calibrator fails,
check the batteries first, and replace them if needed.
Verify that the Calibrator is being operated in accordance
with the instructions in this manual. If the Calibrator is
faulty, send a description of the failure with the Calibrator.