Fluke 725Ex - Measuring Electrical Parameters (Lower Display)

Using Measure Mode
21
Measuring Electrical Parameters (Lower Display)
To measure the electrical parameters using the lower
display, proceed as follows:
1. Connect the Calibrator as shown in Figure 9.
2. If necessary, press
M for MEASURE mode (lower
display).
3. Press
V for dc voltage or current, or F for
frequency or resistance.
V mA
LOO P
V mA
TC RTD
˚
C
˚
F
Hz
100%
25%
25%
RECALL
ZERO
MEAS
SOURCE
STORE
SETUP
0%
MULTIFUNCTION
PROCESS CALIBRATOR
725Ex
2004.1573266
LR110460
Zone 0 AEx ia IIB 171 C
I.S. Class I Div 1, Groups B,C,D
aly43f.eps
Figure 9. Measuring Electrical Parameters