345
Users Manual
30
Additional instrument settings include:
Low pass filter: Switch low pass filter ON or OFF to eliminate high
frequency noise.
PF/DPF Mode: Select either Power Factor or Displacement Power Factor.
PF/DPF Display: Select displayed Power Factor.
Harmonics type: Select either %H1 (fundamental) or %RMS.
Date and Time: For time and date stamping of logged data.
Voltage Range Settings
To select either manual or automatic voltage ranging:
1. Press
JK until Voltage Range is selected.
2. Press
FG to change the setting. The available choices are
AUTO, 4 V, 40 V, 400 V, and 750 V.
3. Press
E to confirm required change.
4. To exit without changing, press
M.
Figure 12 shows the voltage range settings for the Clamp Meter.
eln14.bmp
Figure 12. Voltage Range Settings
To Next Page
Loading...
