Clamp Meter
Safety Information
5
• To avoid false readings that can lead to electrical shock and injury, replace the
batteries as soon as the low battery indicator () appears.
• When servicing the Meter, use only specified replacement parts.
• Have the Meter serviced only by qualified service personnel.
• Be careful around voltages > 30 V ac rms, 42 V ac peak, or 60 V dc. Such
voltages pose a shock hazard.
• Do not apply more than the rated voltage, as marked on the Meter, between the
terminals or between any terminal and earth ground.
• When using the probes, keep fingers behind the finger guards on the probes.
• Connect the common test lead before connecting the live test lead. When
disconnecting test leads, disconnect the live test lead first.
• Do not work alone so assistance can be rendered in an emergency.
To Next Page
Loading...
