365
Users Manual
4
• Have the Meter serviced only by qualified service personnel.
• Be careful around voltages >30 V ac rms, 42 V ac peak, or 60 V dc. Such voltages
pose a shock hazard.
• Do not apply more than the rated voltage, as marked on the Meter, between the
terminals or between any terminal and earth ground.
• When using the probes, keep fingers behind the finger guards on the probes.
• Connect the common test lead before connecting the live test lead. When
disconnecting test leads, disconnect the live test lead first.
• Do not work alone so assistance can be rendered in an emergency.
• Use extreme caution when working around bare conductors or bus bars. Contact
with the conductor could result in electric shock.
• Adhere to local and national safety codes. Individual protective equipment must
be used to prevent shock and arc blast injury where hazardous live conductors
are exposed.
• Disconnect circuit power and discharge all high-voltage capacitors before you
do diode tests or measure resistance or continuity.
• Do not measure ac/dc current in circuits carrying more than 600 V or 200 A with
the Meter Jaw.
• Never operate the Meter with the back cover removed or the case open.
To Next Page
Loading...
