CAT III 1500V TRMS Clamp Meter
Basic Measurements
13
If the iFlex Probe does not work as expected:
• Make sure that the coupling system is connected and closed correctly or look for any
damage. If any foreign material is present, the coupling system will not close properly.
• Inspect the cable between the iFlex Probe and the Clamp for any damage.
• Check that the control knob is in the correct position
O.
Figure 2. Flex Probe Setup
<0.5 A
>0.5 A
1 2 3 4
>2.5 cm
>1 in
To Next Page
Loading...
