Laser Distance Meter
Measurements
21
5. Push at the top target. Height Tracking stops
and the display shows the vertical distance between
the two measured targets. See Figure 12 for more
information.
Note
The minimum/maximum tracking is very helpful
for 90 ° angle measurements. See page 17 for
more information.
h3
h1
X
Y
h2
12
gwo10.eps
Leveling
The Leveling function continuously shows the angle of the
Meter. From an angle of ±5 °, the Meter starts to beep. As
it gets near ±1 °, the Meter beeps faster. At ±0.3 °, the
Meter beeps constantly.
To level:
1. Push
3x = Leveling. shows in the display.
2. Put the Meter on object to do a test for level.
The angle continuously shows on the display as the
object moves.
To Next Page
Loading...
