Fluke 435-II User Manual

Fluke 434-II/435-II/437-II
Three Phase Energy and Power Quality Analyzer
Service Manual
PN 4822 872 05408
Febr. 2013
© 2013 Fluke Corporation, All rights reserved.
All product names are trademarks of their respective companies.
Advanced Test Equipment Rentals
www.atecorp.com 800-404-ATEC (2832)
®
E
s
t
a
b
l
i
s
h
e
d
1
9
8
1

Fluke 435-II Specifications

General

Category	Power Quality Analyzer
Frequency Range	42.5 Hz to 69 Hz
Harmonics Measurement	Up to 50th harmonic
Battery Life	Up to 8 hours
Safety Rating	CAT IV 600 V / CAT III 1000 V
Inrush Current	Yes
Flicker	Yes
Mains Signaling	Yes
Motor Analysis	Yes
Data Logging	Yes
Voltage Measurement Range	Up to 1000 V
Current Measurement Range	Depends on current clamp used
Display	Color LCD
Power	Rechargeable Li-ion battery

Summary

Safety Instructions

1.2 Safety Precautions

Essential safety procedures for operating and servicing the Analyzer.

1.3 Caution and Warning Statements

Definitions and purpose of Caution and Warning statements.

1.4 Symbols

Explanation of symbols used on the Analyzer and in documentation.

1.6 General Safety Information

General safety practices to avoid electrical shock and injury.

Performance Verification

4.1 Introduction

Introduction to procedures for verifying Analyzer performance.

4.2 Equipment Required for Verification

4.7 Verification of Current Inputs

Procedures for verifying the accuracy and bandwidth of current inputs.

4.8 Voltage Inputs

Procedures for verifying the accuracy and bandwidth of voltage inputs.

4.9 Channel Isolation

Calibration Adjustment

5.1 General

5.2 Calibration Procedure Steps

Outline of the steps involved in complete calibration adjustment.

5.3 Starting The Calibration

Steps to initiate the calibration mode and set initial parameters.

5.6 Final Calibration

Steps for performing the final accuracy adjustments of the Analyzer.

5.7 Save Calibration Data And Exit

Disassembling the Analyzer

6.2.3 Opening the Analyzer, Removing the Battery Pack

Procedure for opening the case and removing the battery pack.

6.2.4 Getting access to Top Side of PCA

6.2.5 Getting access to Bottom Side of PCA

6.2.6 Getting access to LCD, Keypad Foil and Keypad