Fluke 8024B - Page 29

8024B
RESISTANCE (£2)
OFF*
Le
op
IN
FOR
TONE
AX
A
A
OUT
FOR
SILENT)
CONE
Fs
IN
FOR
20kQ
<
RANGE
IN FOR QQ
FUNCTION*
The PEAK-HOLD switch and Function switches are push-push
type. Operate these switches by pushing to the RIGHT ® only!
Do not push or pull these switches to the left (out or off) positions.
®Connect the test leads as shown.
®Depress the mA-°C-V-Q-S switch.
@Depress the grey switch beside the range desired (20k is shown
selected.
@insure that all other switches are at the out or OFF positions.
@Make sure that the device being measured contains no elect-
rical energy.
WARNING
TO AVOID ELECTRICAL SHOCK AND/OR INSTRUMENT DAMAGE,
DO NOT CONNECT THE 8024B TERMINALS TO SOURCES THAT
EXCEED THE FOLLOWING LIMITS WHEN MEASURING
RESISTANCE OR CONTINUITY:
COMMON: 500V DC OR AC RMS WITH RESPECT TO EARTH
GROUND.
V-(Q2-S: 500V DC OR AC RMS WITH RESPECT TO THE COMMON
TERMINAL.
®Connect the test leads across the device being measured.
®Read the measured value on the display.
Figure 2-8. Resistance Operation